Currently coal bar machine produced coal rods heat is relatively high, and after heating coal after extrusion and viscosity will be increased, so that when we use coal will save more energy. Produced by conventional coal briquettes machine sticks and briquettes, a loose and relatively dry. In a burning need to go through a long period of time before they can be burning hot. Coal bar machine from the operation is more convenient than traditional briquettes machine is to be more labor-saving. There are many ways saving, if every detail from the start, it must be able to save a lot of electricity. For example, every day, according to the production needs to choose to open several coal bar machine, rather than open, the better, do not need it as little as possible coal bar machine. But also to feed my good time, the motor starts to be reasonable, do not start simultaneously. When you have good control of charging current, the current is too large or too small are bad. Especially in the quick start if a sudden after feeding, then, the current will run high, damage to the machine. In addition, the production of coal rods to be used when lighting, lights switches to be installed separately, can be turned off when not in use, do not overload. Each time you use coal rods extruder check again before the motor wiring head, check the wires, power supply is normal, etc., which are to be done. If the power to do all aspects of the work, and that power is not difficult. Source: www.zzryjx.cn www.henanhuanbaojixie.com Tel: 15565057786